Demagnetising system ENTMAG S

ENTMAG S demagnetises ferromagnetic workpieces up to 150 mm thick using powerful low-frequency pulses below 0.5 mT.

Dimensions [mm]: 700 x 540 x 800
Voltage: 380

Technical data

Model	Dimensions [A x B x H]	Active area	Weight
	[mm]	[mm]	[kg]
HD-SM3050	700 x 540 x 800	500 x 300	180

Show complete technical data

With the ENTMAG S, small to large ferromagnetic workpieces can be demagnetised quickly and easily directly on the table surface.
Powerful low-frequency pulses sink deep into the material and reduce the residual field to below 0.5 mT.
The included Tesla meter measures the result with an accuracy of 0.1 mT.
The workpiece is placed in position, started at the touch of a button and is free of residual field after a maximum of 20 seconds.

Why demagnetizing?

All the ferrous and ferromagnetic materials are capable of creating magnetic zones. This may occur with the raw material storage, with magnetic crack and hardness tests, cold forming, chip cutting, measuring or magnetic clamping and lifting.

Basically, magnetism is not harmful, but may prove interfering with further processing.

While demagnetizing, the magnetic field in the workpiece gets neutralised. The workpiece is magnetically neutral. The demagnetizing effect can be obtained by intense heating or a very strong external magnetic field. After demagnetization, the magnetic forces in the workpiece have disappeared. The magnetic field can be restored through remagnetization.